Belly pan

[Alfor]

Got a few marks on the bellypan after a few mistakes does anyone know of an aftermarket belly pan supplier?

Cheers,

Allan

[Burchy]

Never heard of seen of one.  eBay is probably going to be the answer

[Lonewolf]

Please tell us about the mistakes. 

[O.C.]

You could try here, there are lots of parts available so you will need to trawl for your  requirement  


https://www.ebay.co.uk/str/dkmotorcyclespares     

[Burchy]

Half of it here: -

https://www.ebay.co.uk/itm/Genuine-Kawasaki-GTR-1400-lower-left-side-fairing-cowl-infill-trim-07-08-09-10/264181570996?hash=item3d8272ddb4:g:AkUAAOSwZ-9cWaBl

Oops Wrong version!

[doebag]

Allan

Confirm yours is a facelift 2010 model ?

If so I may have what you need.

[Alfor]

Allan

Confirm yours is a facelift 2010 model ?

If so I may have what you need.

Yes, it is the facelift 2010

[Alfor]

Please tell us about the mistakes. 

Managed to bounce off a TNT truck on the near side last year and this year managed to gentle let it down on the off side after a miss footing (well that's my excuse l9l) 

[Lonewolf]

It happens to the best of us....I had the misfortune of dropping my GSA twice in a day! I can laugh about it now, but at the time I was not a happy chap. 

[doebag]

Alan
Pictures 1-4 are l/h side. 5-8 are r/h side

All tabs and fasteners are ok, only damage is to the raised rim areas. These would smooth out with some fine sand paper and some 'back to grey'

[Alfor]

Alan
Pictures 1-4 are l/h side. 5-8 are r/h side

All tabs and fasteners are ok, only damage is to the raised rim areas. These would smooth out with some fine sand paper and some 'back to grey'

Thanks, my are exactly the same. Thought I might be able to get a replacements or 3rd party carbon fibre.

[doebag]

Thanks, my are exactly the same. Thought I might be able to get a replacements or 3rd party carbon fibre.

I suspected they might be, never mind I'll give them a clean and stick them on fleabay with some other bits and pieces.

[Burchy]

Why don't you clean them up, smooth off the rough edges and get them carbon dipped?

www.wickedcoatings.co.uk

They do a lot of this for Bournemouth Kawasaki with impressive results

[Alfor]

Why don't you clean them up, smooth off the rough edges and get them carbon dipped?

www.wickedcoatings.co.uk

They do a lot of this for Bournemouth Kawasaki with impressive results

Looks good that, will get a price from them - cheers!