Hi all.
Just to let you know I purchased two covers for the brake reservoir that mount ram balls .
From motorcycle larrys a good bit of kit a bit pricey with the delivery but as I said well made.
Fitted a treat as stated.my problem on the 2014 bike is when locking the ball hits the screen if you raise the screen a bit it clears but if you keep forgetting who knows .
Admittedly full lock will probably only be on slow manoeuvring.but be aware if thinking of fitting .
http://www.motorcyclelarry.com/index.php?main_page=product_info&cPath=59&products_id=186
Well... I had the same ones as yours... I simply cut the other end that hit the wind shield... :punk:
Quote from: Stoner on February 21, 2017, 04:45:39 PM
Well... I had the same ones as yours... I simply cut the other end that hit the wind shield... :punk:
A nice easy fix if you only need a single ball mount
If u r was me .. I would cut the offending protrusion off .. centre drill the ball out to 3.4 mm .. cut thread with a M4 tap .... drill a hole in the plate (it looks thick enough ) use either a countersunk 4mm flush head cap bolt or a dome head ..and voila both ya balls back in place :smiley:
There's nowt worse than having yer balls out of place, the re-arrangement process whilst personally satisfying can also prove to be embarrassing for onlookers :mfr_lol:
You can just leave the 1 off it's ok then passes the screen ok.
As I stated it would only be on slow manovering with full lock on :yes:
Quote from: pross on February 22, 2017, 09:28:46 AMr
You can just leave the 1 off it's ok then passes the screen ok.
As I stated it would only be on slow manovering with full lock on :yes:
AAAHAAAA ! The cure then is ......
Divvent drop below 39MPH and if ya needs to get inta a tight space without interfering with ya balls .. power slide her round :mfr_lol: :mfr_lol: :biker3:
:mfr_lol: :mfr_lol: :mfr_lol:
Quote from: pross on May 30, 2016, 03:42:08 PM
Hi all.
Just to let you know I purchased two covers for the brake reservoir that mount ram balls .
From motorcycle larrys a good bit of kit a bit pricey with the delivery but as I said well made.
Fitted a treat as stated.my problem on the 2014 bike is when locking the ball hits the screen if you raise the screen a bit it clears but if you keep forgetting who knows .
Admittedly full lock will probably only be on slow manoeuvring.but be aware if thinking of fitting .
http://www.motorcyclelarry.com/index.php?main_page=product_info&cPath=59&products_id=186
Those mounts appear very high up. I have ram mounts on the clutch and brake lever h/bar clamps. Doesn't effect steering or screen movement. :smiley:
Quote from: Kylinski on February 22, 2017, 07:25:14 PM
Those mounts appear very high up. I have ram mounts on the clutch and brake lever h/bar clamps. Doesn't effect steering or screen movement. :smiley:
You could be right how high they are with the thread well said :yes: