Quote from: pross on June 30, 2021, 05:35:37 PMYou can press both clock buttons in this will stop the flashing but you have a red light on display.
And you have to do it every time you start the bike 🤬🤬 .
Excellent - thank you!!
1400 GTR - A beast
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: pross on June 30, 2021, 05:35:37 PMYou can press both clock buttons in this will stop the flashing but you have a red light on display.
And you have to do it every time you start the bike 🤬🤬 .
Quote from: Burchy on November 07, 2019, 06:34:25 PM
Why don't you clean them up, smooth off the rough edges and get them carbon dipped?
www.wickedcoatings.co.uk
They do a lot of this for Bournemouth Kawasaki with impressive results
Quote from: doebag on November 06, 2019, 03:27:54 PM
Alan
Pictures 1-4 are l/h side. 5-8 are r/h side
All tabs and fasteners are ok, only damage is to the raised rim areas. These would smooth out with some fine sand paper and some 'back to grey'
Quote from: Lonewolf on November 04, 2019, 08:00:04 AM
Please tell us about the mistakes.
Quote from: doebag on November 04, 2019, 04:42:58 PM
Allan
Confirm yours is a facelift 2010 model ?
If so I may have what you need.
does anyone know of an aftermarket belly pan supplier?
Quote from: tapps on April 23, 2018, 05:51:04 PM
if you take it to the STEALER'Sthey will charge you approx £225 per sensor fitted.