Hi all. I have just purchased the kawasaki satnav bracket.that uses four of the six handle bar fittings.
Is there a torque setting for this or just tight as f#*k !!. :ohplease:
Any help gratefully received. Thanks pross. :sweatdrop:
From the workshop manual, it will be either of these
Handlebar Bolts 34 Nm 25 ft-lb
Handlebar Holder Bolts 25 Nm 18 ft-lb
So no, definitely NOT tight as fuck :wink:
Bit of thread lock as insurance
Or as my father said about all fasteners: "Pull until your lower lip trembles...."
Quote from: bacaruda on February 03, 2014, 09:37:46 PM
Or as my father said about all fasteners: "Pull until your lower lip trembles...."
:mfr_lol: :mfr_lol: :mfr_lol:
nice and tight and then another 1/4 turn for luck, check it after 50 miles and you are golden .
Just use a good fitting Allen Key and the arse-clench torque qrench
But whatever you do.....don't strip those threads! :sweatdrop:
Quote from: The Wolf on February 03, 2014, 10:07:08 PM
But whatever you do.....don't strip those threads! :sweatdrop:
Agreed..... its not a good look to be bouncing down the road on yer arse with just a pair of bars in yer hands :mfr_lol:
thank all for the input. :clap: :clap:
pross