Looking for the front accessory leads. I have taken the glove box out, but cannot find them. Any suggestions
Ta!!!
Tom
I also took the black panel off surrounding the glove box, not difficult, then the wires are in a shiny black plastic surround.
Its a lot easier with this panel removed, go for it, if i can do it anyone can.
Alan
Alan
Many thanks
Off to do it
Tom
Alan
STAR!!!!
Found them. I remember it took ages to find the rear ones. Obviously K do not want you to fit accessories!!
Thanks
Tom :banana: :banana: :banana: :banana:
Does this mean i am an expert motorcycle sparky?
I think not, Lonewolf told me ages ago where it was.
Alan
from memory the accessory lead i used goes into standby mode when the bike is at tickover, a tad annoying if your satnav is attached to it, cant remember which lead it was yho, i used a feed from my side lights in the end
Viper, not heard of that before. I've never experienced any loss of power in the sat nav, or autocom etc whilst at traffic lights etc.
Quote from: Lonewolf on June 21, 2012, 01:43:09 PM
Viper, not heard of that before. I've never experienced any loss of power in the sat nav, or autocom etc whilst at traffic lights etc.
+1 Never had a problem with my sat nav connected.
Alan
yeh, I initially wired my satnav into the same feed as the heated grips, this circuit is a power saving circuit and cuts out when the bike is at tickover, it has caught a few out in the past , check this thread
http://www.1400gtr.org.uk/forum/viewtopic.php?f=22&t=1048
Use the accessory/aux power supply as fitted to the bike and power will only cease when the bikes ignition is switched off