is it an easy job to replace the running/side light's,i have aquired a pair of ultra led 501's to replace the oem bulb's.looking at where the bulb's are situated it look'd a bit fiddly to say the least.any pointer's.
15 min job, hand down inside the fairing and twist out the holders. It is easier to undo the panel under the headlight via the plastic pop rivets, easier to get your hand in :ninja:
I normally undo the panel.
Sometimes its longer to put the panel back than swap lights
im sure someone else asked about this a while back and then said it took them several hours :shocked:
Yep .. I remember .. someone was going to take the fairing off but it's a matter of getting your hands on those twisty bits and your in ! :laugh:
someone must have bloody small hands coa i cant get my mits anywhere near the running lights..... methinks i'll be leaving it :surrender:
Quote from: Mogster on April 06, 2012, 09:33:14 PM
someone must have bloody small hands coa i cant get my mits anywhere near the running lights..... methinks i'll be leaving it :surrender:
TBH i found it a tad difficut to get hands in without scraping your skin against all the kawasaki sharp cable ties. Honestly the panel under the headlight comes off in a snap, no tools required , well maybe a matchstick