Wherre the F are they??????????

[vfrtom]

Looking for the front accessory leads. I have taken the glove box out, but cannot find them. Any suggestions
Ta!!!
Tom

[BigAlan]

I also took the black panel off surrounding the glove box, not difficult, then the wires are in a shiny black plastic surround.

Its a lot easier with this panel removed, go for it, if i can do it anyone can.

Alan

[vfrtom]

Alan
Many thanks
Off to do it
Tom

[vfrtom]

Alan
STAR!!!!
Found them. I remember it took ages to find the rear ones. Obviously K do not want you to fit accessories!!
Thanks
Tom

[BigAlan]

Does this mean i am an expert motorcycle sparky?

I think not, Lonewolf told me ages ago where it was.

Alan

[viper]

from memory the accessory lead i used goes into standby mode when the bike is at tickover, a tad annoying if your satnav is attached to it, cant remember which lead it was yho, i used a feed from my side lights in the end

[Lonewolf]

Viper, not heard of that before. I've never experienced any loss of power in the sat nav, or autocom etc whilst at traffic lights etc.

[BigAlan]

Viper, not heard of that before. I've never experienced any loss of power in the sat nav, or autocom etc whilst at traffic lights etc.

+1 Never had a problem with my sat nav connected.

Alan

[viper]

yeh, I initially wired my satnav into the same feed as the heated grips, this circuit is a power saving circuit and cuts out when the bike is at tickover, it has caught a few out in the past , check this thread

http://www.1400gtr.org.uk/forum/viewtopic.php?f=22&t=1048

[O.C.]

Use the accessory/aux power supply as fitted to the bike and power will only cease when the bikes ignition is switched off